#FIRE EXTINGUISHER ACRONYM HOW TO#

If the extinguisher is empty and the fire is not out, evacuate immediately.

Use the PASS technique for discharging an extinguisher and back away from the area if the fire flares up again.

Do not allow this evacuation route to become blocked.

Before approaching the fire, determine an evacuation route safe of flames, excessive heat and smoke.

If appropriate, sound the fire alarm or call the fire department immediately.

Employee responders to a fire also should be trained to adhere to the following protocol:

#FIRE EXTINGUISHER ACRONYM HOW TO#

Knowing how to operate the extinguisher is not the end of training. OSHA requires employees to be trained in fire extinguisher use on an annual basis, at a minimum. OSHA requires employers to thoroughly train workers not only how to use an extinguisher properly, but also how to accurately assess a situation and determine when evacuation is the safest course of action. If the fire begins to recede, adjust your position and continue to spray as long as the extinguisher allows. If the fire re-ignites, repeat steps 2 – 4.

S – Sweep: Sweep from side to side at the base of the fire until it appears to be out.There is a limited amount of the agent inside every extinguisher, so use it wisely and squeeze only to get a controlled amount. S – Squeeze: Squeeze the handle to release the extinguishing agent.NOTE : Do not touch the plastic discharge horn on CO2 extinguishers, it gets very cold and may damage skin. By targeting the base you are tackling the fuel source of the fire and putting the extinguishing effect in the right place. A – Aim: Aim low, pointing the extinguisher nozzle (or its horn or hose) at the base of the fire.P – Pull the pin: This will also break the tamper seal and then allow you to activate the extinguisher, releasing the locking mechanism.Most fire extinguishers operate using the following P.A.S.S.

Fire extinguisher acronym